shorttie714

shorttie714

BTC Adam and Eve pattern with both 2 and 3 wave scenarios from the neckline breakout

shorttie714

Costco Areas of Interest for Short or long entries.

shorttie714

ATOM Playbook idea with several patterms and trends and liquidity areas

shorttie714

US10Y decision coming very soon. Possible M Breakdown with 5th wave down, or retrace for shoulder.

shorttie714

PIUSDT Short to clear test the support / recent lows. I believe it goes even lower.

shorttie714

Diamond Pattern Upside Down signifying the bottom area of the local region, Unless Invalidated by striking through the center of the Diamond, and then re-tested at center of diamond fails as well would mean a nice short setup, but for now its Green and Up unless the above.

shorttie714

BTC Diamond Top not fully formed yet, needs to tap the lower right quadrant again yet. And then we could still see a false breakout direction from the diamond, the center of the diamond needs to act as resistance either way, for confirmation otherwise its invalidated.

shorttie714

Bullish Divergence & Breakout Idea with FIb Targerts

shorttie714

BTC Cup & Handle Pattern, back test must hold to confirm, then up. Ref Example: www.quantifiedstrategies.com

shorttie714

Lina Short Inverse Term Head and shoulders / recovery bounce

shorttie714

S Curve Idea dependent upon breaking crucial key trend lines to enter the super S curve.

shorttie714

Walmart - parabolic phase or break Some stair cases and now inverted count possible to watch Daily breakout to 99-100 area target and possible continuation, parabolic line give or take a little , close a solid candle below it on daily, not a wick to break .

shorttie714

MACD shows weakening sell cycles, monthly lows in blue

shorttie714

Tesla Short , consolidating with possible right shoulder.

shorttie714

BTC Long Channel Forming and expecting some explosive momentum.

shorttie714

BTC Long - BTC Accumulation and adoption rate growth expanding rapidly.

shorttie714

BNB Cup and Handle, and Head and Shoulders, with Entry point and TPs.

shorttie714

Bit Cup and Handle...... How high can we go ??????